Alsa Refinish MC-101GKit Instrukcja Obsługi Pobierz pdf

MirraChrome

HOW TO APPLY MIRRACHROME:

Surface Preparation:

1 Always apply paints in a well-ventilated area, and wear a NIOSH approved respirator to

avoid breathing any fumes.

2 Make sure you have good conditions for spraying. The best temperature for spraying this

paint, is 75-80 degrees F, and VERY low humidity.

3 Prepare and prime your part first. Epoxy primers are best for bare metal, and primer

surfacers are best for plastics, fiberglass, or wood. Some plastics may require an

adhesion promoter but most plastics, like ABS plastic, are fine without adhesion

promoters. Our tech support department can assist with what primer is best, if you are

uncertain.

4 Before applying your primer, remove all dirt, grease, oil, salt, and chemical

contaminants, by washing the surface with a commercial detergent, or other suitable

cleaning method.

5 Rinse with fresh water and allow to completely dry.

6 Remove any existing loose paint, or rust, etc, with a wire brush or sand paper.

7 Lightly sand glossy surfaces to create a surface profile for adhesion.

8 Apply your primer to the surface according to the manufacturers specifications for your

particular primer.

9 Let your primer cure according to the manufacturers specifications for your particular

primer, and then lightly scuff that to create a surface profile for adhesion.

Mirrachrome Application:

Mirrachrome is a VERY technique driven application. It is sold as a kit, as it is very sensitive to

clears. You should only use OUR clear coat with this material.

This application can take a fair amount of practice to become proficient with. Patience is the

KEY.

Test panels are strongly urged, in order to develop the correct “FEEL” for spraying the chrome

material. A very light dusting technique will be needed, and is critical to the application. Over

applying the Mirrachrome will result in a dull finish, similar to silver paint.

Application:

1 2 3 4

MirraChrome 1

Podsumowanie treści

Strona 1 - MirraChrome

MirraChromeHOW TO APPLY MIRRACHROME:Surface Preparation:1 Always apply paints in a well-ventilated area, and wear a NIOSH approved respirator to avoid

Strona 2

If applying over an ALREADY PAINTED SURFACE, lightly scuff the existing paint to create a surface for adhesion.1.) We are starting with the black base

Strona 3

40 PSI air pressure, continuing to make passes over the surface, and VERY BRISK PASSES, until you achieve the effect.Moving your hand too slowly when

Strona 4

If additional coats are desired/required, then after waiting 24 hours for the first coat to cure, lightly scuff the clear, and shoot you additional co

Komentarze do niniejszej Instrukcji

Brak uwag

Alsa Refinish MC-101GKit Instrukcja Obsługi

Przeglądaj online lub pobierz Instrukcja Obsługi dla Nie Alsa Refinish MC-101GKit. Alsa Refinish MC-101GKit Instructions / Assembly Instrukcja obsługi

Podsumowanie treści

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Nie Alsa Refinish MC-101GKit